Funkmaster Kal's akimbos 8800gt's on steroids - Page 5

Kal-EL · #41 04-19-2010

Quote:

Originally Posted by Splave

how much v-loss we talking here?

Its slow and gradual but usually like .02 volts between boots on the vgpu.

HITandRUN · #42 04-19-2010

Quote:

Originally Posted by Kal-EL

Its slow and gradual but usually like .02 volts between boots on the vgpu.

Maybe the trim pot is going bad slowly.

Splave · #43 04-19-2010

could be, if so I can mail you a couple kal if you cant find them locally. Would be easy to pop new ones on if need be

Kal-EL · #44 04-19-2010

Quote:

Originally Posted by Splave

could be, if so I can mail you a couple kal if you cant find them locally. Would be easy to pop new ones on if need be

Thx splave, I think I'll be o.k., its just a quick twist, long as the trimmmer twister thingy doesn't eventually fall out

Splave · #45 04-20-2010

nah

but if it starts to click when you turn it its maxed

Kal-EL · #46 05-02-2010

Ah crapola!

That one that was acting up did its final episode. I mounted the pot on the wrong damned card. Sucker is good to go without the driver installed but once you install the driver "No Video". The other card is strong tho, shouldnt potted that sucker first. Bummer, this cascade's been running for going on 15 hours now, I think it can run while I prep the other card, x-'s fingers

cuz we need about 40 more boints to pass the KGB.

FACE · #47 05-10-2010

Splave, what point did you use for vmem read?

Splave · #48 05-10-2010

green wire brotha man!
http://overclockaholics.com/forums/s...0&postcount=33

FACE · #49 05-10-2010

Did you use the larger cap at the top left? there are 6 there...

Splave · #50 05-10-2010

try these guys