DimasTech BenchTables V2.5

GFDuke · #1 02-15-2010

I can attest that the edges are smooth and finished nice. It is a good piece of work. The only problem i had with the setup was that the cpu hold down rod dosn't exactly line up with the center of the heatsink. I don't use it and i mount my heatsinks with the hardware they came with.

Kal-EL · #2 02-16-2010

Quote:

Originally Posted by GFDuke

I can attest that the edges are smooth and finished nice. It is a good piece of work. The only problem i had with the setup was that the cpu hold down rod dosn't exactly line up with the center of the heatsink. I don't use it and i mount my heatsinks with the hardware they came with.

Was that the V2.5 as well Duke? or the older version?

@Dimas, is there a difference in the arch press between the two?

karmakazi · #3 02-16-2010

Hi Andrea! I will respond to your PM @ XS soon my friend.

These tables are so incredibly clean looking and well designed. I love them!

GFDuke · #4 02-16-2010

Quote:

Originally Posted by Kal-EL

Was that the V2.5 as well Duke? or the older version?

@Dimas, is there a difference in the arch press between the two?

The arch press looks the same to me bro. Seriously i tried to mount my pot for dice action and there was no way i could get the press to center on my pot. So i had to use the hardware that came with the pot.

Dimas · #5 02-17-2010

Quote:

Originally Posted by GFDuke

The arch press looks the same to me bro. Seriously i tried to mount my pot for dice action and there was no way i could get the press to center on my pot. So i had to use the hardware that came with the pot.

so you think we have to include also a Big base on top of Press to distribute better the load?

Witchdoctor · #6 02-17-2010

Instead of sloted holes what if the arch slid in a groove to eliminate fixed positioning laterally.

The arch slides this way across the top but not along the sides of the table.

I am sure this would create weakness if it were slotted the whole way.
A rail system would probably have to be incorperated. I could draw this but I am sure you have engineers that could do it in better detail than myself with a pencil and paper.

It would have to be a U with top rerturns with a opening in the middle. The edge of the table could be solid and may need reenforced to accomidate a tightening mechanism from the bridge itself.

Hope you can picture what I am talking about here. This would create a slide with no limitations just like the top rail of the bridge/Arch .....

Dimas · #7 02-17-2010

Quote:

Originally Posted by Kal-EL

Was that the V2.5 as well Duke? or the older version?

@Dimas, is there a difference in the arch press between the two?

the arch press of the V2.5 is littler couse the table itself it's also littler, probably when Duke it's trying to fix the Arch can't get in the right position couse holes distance are fixed, if some one got some suggestion to improve the ARCH press...