[Neuromancer]

Tuniq Tower with bolt through mod (a 1U opteron heatinsk I cut out to work as a brace) HS yateloon in the heatsink and a panaflo low speed ~ 80CFM 38MM for pressure strapped on with some baling wire.

[Chicken Patty]

Originally Posted by Neuromancer

Tuniq Tower with bolt through mod (a 1U opteron heatinsk I cut out to work as a brace) HS yateloon in the heatsink and a panaflo low speed ~ 80CFM 38MM for pressure strapped on with some baling wire.

customeness FTW


cool, thanks for the info.

[Chicken Patty]

update! Got the watercooling back in

[Kal-EL]

Wow, that's some mighty fine clockin dude. Good work!

[Chicken Patty]

Originally Posted by Kal-EL

Wow, that's some mighty fine clockin dude. Good work!

Thanks bro, i think this thing still has a bit more to go, I stopped upon the first reboot. Talk about been lazy!

[Kal-EL]

what'd u boot up with?

[thebanik]

Originally Posted by Chicken Patty

Thanks bro, i think this thing still has a bit more to go, I stopped upon the first reboot. Talk about been lazy!

push it man, push it.....In my test, 2 chips I was able to take them to above 4800Mhz with HT off for 2d runs on air, and you have water..........

[Chicken Patty]

Thanks guys. I booted up at 4.2 ghz I think, they used eleet to go to 4.628ghz. When it crashed there (4.628 Ghz @ 1.388v i believe) thats it I stopped. I rebooted at 4.528ghz did the 3druns and thats it, booted again at 4.3ghz which is what i has been since for crunching.

[Rogue210]

ur on it chx patty...keep going

[Chicken Patty]

Originally Posted by Rogue210

ur on it chx patty...keep going

I will shortly.