2 sheets of 1/2 in insulation snug it down nicely. Its even a bit tight. So be careful and tighten down the mobo screws like you would putting a tire on a car. Go opposites and only a turn at a time on each until its tightened all the way. If you do them about 1/2in past the mobo edges then you'll have no need to put anything on the back of your motherboard to insulate it.
__________________
DUKES PC MODING PAGE
Ferengi rule of acquisition #8: " Small print leads to large risk. "
Last edited by GFDuke; 03-26-2010 at 12:28 PM.
|
acebook
Threaded Mode