[Buckeye]

5.7ghz on Cascade so far

[MaadDaawg]

Should have my 760 Hydor Cooled up and running tomorrow with the SS for the CPU and water for the chipset & moffsets. Bookmarked your settings and I'll give em a try and let you know. In process of watering my 758 but that'll probably be a wokr or two off due to work schedule :( my DomGTs crapped out and are at Corsair awaiting arrival of the new improved version... in the meantime I'm going to try out the OCZ 2133 PC3-17000 blades and see what they'll do. Couldn't stand it at 1866 Cas 9 even as a temporary solution

[Chuchnit]

Not bad. How are the evap temps with a PHII load?

[dinos22]

246.4MHz bus is ok
i can bench 1M but 8M wont go past first loop

http://valid.canardpc.com/show_oc.php?id=607138


i dont really need to push more here even if i wanted to use 23x

hehehe

[Chuchnit]

Originally Posted by dinos22

246.4MHz bus is ok
i can bench 1M but 8M wont go past first loop

http://valid.canardpc.com/show_oc.php?id=607138


i dont really need to push more here even if i wanted to use 23x

hehehe

Nice Dinos Is that a 960 or 965 EE? I'm confused on all these cpuz shots I'm seeing like this. You aren't the only one either. Plus what is you 3d benchable goal for this cpu?

[sofos1990]

very nice dinos!
What about max bclk frequency?Just for validation!
What is the max bclk for 3d?

[Chuchnit]

Sweet. Why isn't it showing up as ES?

[RomDominance]

I kinda suspected the 960....couldn't understand why you were keeping the multi so low....dawg!

You'll prolly see better results at lower bclk and higher multi....TURBO OFF....of course.

In regards with the ram, I haven't screwed with the rr and my trfc stays at 59 with the 920....I do like to run it at cas 6 when below 1750 though and that makes a nice little difference when it comes to 2d in most cases.

[dinos22]

just tightened things up a bit to see how efficient the performance is

looks good

[Kal-EL]

Nice one Dinos! On air?