[Cecil]

Originally Posted by HITandRUN

Well I assume the IC above the memory controller runs the voltage to the core of the card but it is hard to say for sure with our the data sheet and an actual trial and fail procedure since I can’t find anybody else who has done this already. Are you planning to voltmod the memory as well and is this your thread? Looks like you say that the resistance you have there is 570 Ohms so a 10 or 15Kohm VR should do the job for you on the memory.

I can do the mem too, they only hit 1050Mhz.
I have two 10k VRs, so Ill just use them in the mem. Do I just solder it to pin 4 and pin 7?
It is my thread.