[HITandRUN]

Originally Posted by Cecil

I pulled one of the cards out, and have been using that.

The one above the far left one says
BN-BD
M23

and has 24 pins, 6 on each side.

Well I assume the IC above the memory controller runs the voltage to the core of the card but it is hard to say for sure with our the data sheet and an actual trial and fail procedure since I can’t find anybody else who has done this already. Are you planning to voltmod the memory as well and is this your thread? Looks like you say that the resistance you have there is 570 Ohms so a 10 or 15Kohm VR should do the job for you on the memory.