[Buckeye]

5.7ghz on Cascade so far

[Chuchnit]

Not bad. How are the evap temps with a PHII load?

[dinos22]

246.4MHz bus is ok
i can bench 1M but 8M wont go past first loop

http://valid.canardpc.com/show_oc.php?id=607138


i dont really need to push more here even if i wanted to use 23x

hehehe

[sofos1990]

very nice dinos!
What about max bclk frequency?Just for validation!
What is the max bclk for 3d?

[Chuchnit]

Originally Posted by dinos22

246.4MHz bus is ok
i can bench 1M but 8M wont go past first loop

http://valid.canardpc.com/show_oc.php?id=607138


i dont really need to push more here even if i wanted to use 23x

hehehe

Nice Dinos Is that a 960 or 965 EE? I'm confused on all these cpuz shots I'm seeing like this. You aren't the only one either. Plus what is you 3d benchable goal for this cpu?

[Chuchnit]

Sweet. Why isn't it showing up as ES?

[RomDominance]

I kinda suspected the 960....couldn't understand why you were keeping the multi so low....dawg!

You'll prolly see better results at lower bclk and higher multi....TURBO OFF....of course.

In regards with the ram, I haven't screwed with the rr and my trfc stays at 59 with the 920....I do like to run it at cas 6 when below 1750 though and that makes a nice little difference when it comes to 2d in most cases.

[dinos22]

just tightened things up a bit to see how efficient the performance is

looks good

[Kal-EL]

Nice one Dinos! On air?

[dinos22]

Originally Posted by Kal-EL

Nice one Dinos! On air?

RAM is on air
but CPU on SS of course
there is no way a CPU can run that high on AIR lol