So I got my single stager fixed ;)
 

by fixed I mean had Runmc at XS make me one ;) its a tank :thumbsup:
build quality is a litttttle bit better then the last SS I purchased from someone else lol

http://www.under-the-ice.com/SingleS...ler/Splave.jpg

will get the other one fixed up later. :thumbsup:
should be here next week ftw. cant wait to run 32m with this instead of pouring for 6 minutes straight over and over

Ron's stuff is nice .............. :thumbsup:

He ain't cheap for compressors by themselves though.......... :laughing:

ya think that build quality is better :P

Looking good Bro. When you get your old one back you can run the dual SB-e boards :D

Yes, my SS from ron is clean as hell with the wiring and brazing work. It's pretty much same SS, just different condensers, and routing of tubing because of that.

@Witchdoctor
How about this 24k BTU beast You just gotta have a 230 to run it on (i have one right by my benching area). Since it's R410A is can get colder than a r507 (do people just not do r410a because technically you need epa cert for it, though you can buy it on ebay). And with a tad over 2hp i'm sure it can get pretty freaking cold... pull a vacuum of 1 inch and you got -58.. of course you need a 24k btu condenser too... Just thought it would make a killer SS.. and loud too.

I just wish I knew how to fix Ricks cascade so I could buy it :D

Pretty sick condenser, but would it be worth another -10C ?

10C plus an extra 300W heat load :)

Well he is running a 2500k at -42c right now 1.7v sounds good so far

It would not be pratical to use a 2 ton compressore and condenser

One thing could you imagine your electric bill? We are talking about a compressor large enough to cool a 1400 square foot house
A two row condensor would have to be at least 4' square with a 800 CFM fan ............ :laughing:

Best place for this is in an AC unit for your house

I used 410A to charge Madds SS a few weeks back ....

I think many newer units will be using it as it is easily availible and cheaper than most other alternatives.

I would not go any bigger than a 3/4 HP rotary for an SS and trust me .... they get hot and are loud

Sounds good Al, I will be checking this out this week on mine :thumbsup:

Looks sick Splave. You can tell Ron takes pride is his work by how clean it is.

Thanks bro! You still have yours? Oh and that -42c is load temp running 1.7v 32m lol which is just what my chip needs.