New Project - Page 3

kikicoco1334 · #1 02-06-2012

dude that's some sexy stuff there!

MaadDaawg · #2 02-06-2012

Thank you Kiki

Good news is I found the extensions for the six pin cables. Bad news is I couldn't find the 8 pin (think I sold them with the Thermaltake they came with).

Good news is, I did a little rearranging and got the cables to fit

In these pics everything is setup and connected. Now, I gotta remove all the power cords to the 3 cards on the left and use that PSU to fill and bleed the loop. Since that will get me to around when the wife comes home, looks like zero hour will be sometime tomorrow morning

Damn, hope it works as good as it looks

Witchdoctor · #3 02-06-2012

tell me this is not your 24/7 ride ...........

MaadDaawg · #4 02-06-2012

Quote:

Originally Posted by Witchdoctor

tell me this is not your 24/7 ride ...........

what a gamer it would make huh

DOM · #5 02-06-2012

Can't wait

punx223 · #6 02-06-2012

pretty sick dude.... yeah SB-E does not scale past -80C in most cases....

you will get to a temp where performance will actually decrease and even sorta stall but you have a slow mode switch on the board that as long as you have LN2 mode enabled will keep you from freezing during unloaded parts of benchmark

thebanik · #7 02-07-2012

Wow!!!!! looks sexy those pics.....cant wait to see the results

MaadDaawg · #8 02-07-2012

Good news is I kicked it over this morning and everything works

Had to reinstall the video driver to get the quad sli recognized then I turned off everything I could think of (and probably then some). Ran Vantage at all stock speeds (47K+) just to make sure I didn't turn off too much and came through with flying colors.

All shut down now to cool off some while I eat lunch, then I'll start playing with the clocks and the volts and see what I can pull out of this

Anticipation.... rofl

Witchdoctor · #9 02-07-2012

MaadDaawg · #10 02-07-2012

Could be very apropo WD

So far it refuses to OC

It hangs at 33 or 66 at times, and at other times hangs at 01 or 03. Won't even boot at the gamers preset for christsake. WTF you you want for a $1K CPU ..

Either I have the crappiest processor built or something else ain't right. Going to let everything warm up, pull the phase head and possibly redo the eraser to make sure it's water tight.

Then, try again...

If that fails, I'll have to check out Intel's crappy overclocking chip warranty

Does LOOK pretty though don't it