[ny_driver]

I forgot to go buy ceramique.....all I have is shin-etsu and plain silicone compound. I used the shin-etsu like you said.

I don't like the torch already. How do you keep from burning shit? The retainer for the pot is plastic. My heatgun gets up to 1200 degrees and it's more controllable I think.

[Hondacity]

plastic? which pot do you have?

only recourse is heat gun then..

[ny_driver]

F1ee

[Kal-EL]

Ugh, just be aware of where you point the torch?

[ny_driver]

Ok well I'm about to go fill the 2 thermoses....brb.....then I'm going to start the computer up again and start pouring, carefully keeping track of the temperature it CB and the temp it takes to CBB.....right? Then I have to maintain the temp as close to the CB as possible.

Does a lot of voltage always help or sometimes makes it worse?

[Kal-EL]

Hold the temp and overclock like you normally would in increments.

[ny_driver]

The delivery guy said he thought that thing pumped like a keg or beerball......I think it's just a valve with a hose, so I'm going to have to remove the top and pour. That should be fun.

[ny_driver]

Now I got a little bit of a cloud out of the nozzle, but still zero pressure and no liquid. You think it will build pressure by morning sitting in the house where it's at least 60F.

I'd like to play tonight, but pouring into a thermos even with a funnel will be quite a challenge by myself. I could probably rig up a filling station somehow.

[Kal-EL]

Huh? you have an extraction device and are waiting for pressure build up?

[ny_driver]

Yeah, the tank has zero pressure probably because there is no air inside so I've been told. Plus it was sitting outside in the garage where the temp is ~20F for a few hours.