MARCH MADNESS

PhIlLy ChEeSe · #1 04-22-2012

OK,
After updating drivers (last ones loaded are the USB AM something) it will boot to the cursor and keep on blinking? Even tried a fresh install same thing happened

.

MaadDaawg · #2 04-22-2012

If you are not at default clocks and volts, set everything to default. This board is real touchy.

BTW, your new avatar is obscene and disgusting (solely because that's not MY lap she's on

). Please remove it and send me an 8 x 10 glossy

:

PhIlLy ChEeSe · #3 04-22-2012

Quote:

Originally Posted by MaadDaawg

If you are not at default clocks and volts, set everything to default. This board is real touchy.

BTW, your new avatar is obscene and disgusting (solely because that's not MY lap she's on

). Please remove it and send me an 8 x 10 glossy

:

@MD

I'll try one stick of mem, can't enter OS in safe mode

MaadDaawg · #4 04-22-2012

these board are finaky (spelling?) If you're on optimal defaults, then... not sure..
Mine does that if I set the bclk above 100

well, actually over about 103.5

good luck Bro

Splave · #5 04-22-2012

Quote:

Originally Posted by PhIlLy ChEeSe

OK,
After updating drivers (last ones loaded are the USB AM something) it will boot to the cursor and keep on blinking? Even tried a fresh install same thing happened

.

IDE mode?

PhIlLy ChEeSe · #6 04-22-2012

Quote:

Originally Posted by Splave

IDE mode?

I'll try it, think i got a bad SSD after drivers loaded