Moving into colder waters-build log I guess

Neuromancer · #1 08-25-2010

FYI.. you only need 3+ GHz on cpuNB speed if you are running 2000+MHz ram.

Rule is 3 times ram speed (2000 = 1000MHz)

However faster cpuNB can help in 2D tasks the difference is pretty minimal. For benching I increase it (hey if it is an extra couple seconds in 32M I am in

) but for general overclocking not necessary.

ny_driver · #2 08-25-2010

Thanks for that information. I have never heard that formula/rule before.

Off to test the 965...if it works I shut down and this afternoon I re-insulate the board and try again with no grease.

ny_driver · #3 08-25-2010

So it seems the cpu wasn't the problem. Another motherboard, I just RMAd it a month ago. New one should be here Friday.

I'm hooking up the 939 rig tonight as my laptop seems to be ill.

spfoam1 · #4 08-26-2010

This thread sure brings some interesting memories back. My congrats to the addicted one! Amazing build.

ny_driver · #5 08-27-2010

Thanks a lot bro! Got the new Crosshair IV just now from ASUS advanced RMA/fedex overnight.

Apparently I failed to insulate well enough on the last board or maybe it was a leak, but either way........ I don't want to let this happen again. I think I'll use thin strips of electrical tape to keep the dragon skin from seeping under things.

Don't you guys get condensation forming around the edge of where the cpu is making contact with the HS, and then dripping down into the cpu socket? I'm very concerned about this now, because that seems like the most likely place for water to get where it isn't supposed to.

I need some advice...going to be re-insulating later on after I make sure everything is working.

Thanks!

FACE · #6 08-27-2010

The trick in both Lga and PGA sockets is to make the cpu area air tight. I do not put grease in or around the socket. Sealing the area around the cpu with eraser works fine by itself. you can insulate up the side of the socket and cpu to the very top edge of teh ihs and not interfere with the cooler (wb/ evap/pot) at all.

so I would try the eraser method until you get the dragon skin method perfected. Make it thin on the mobo, and gradually mound it up around teh socket until you have it up level with the cpu. Make sure it is pressed tight to the sides of the socket and cpu and your worries are over.

ny_driver · #7 08-27-2010

Thanks FACE, I'm going to get the kneaded eraser and use that in addition to the dragon skin right around the socket and give it another go.

I'm up and running again with the 965BE now.

I stuck my bad memory module in the freezer for like 2-3 days and it works again too.

I'm ready to party dudes

!