Quote:
Originally Posted by Kal-EL
Thats what I figured with the fatty. Q? What are you guys doing for ram thats placed in the gap between the pot and the pcb? Are you leaving it barren with no ramsink (regulars dont' fit) or are you cutting a ramsink fin down to size and slipping it in there?
|
Quote:
Originally Posted by HITandRUN
Dont need any ram sink there mate at lest I dont put anything on the rams. The are is dead cold anyway!  |
Yep, and on top that.
Many (and I have a card right now like this) have said if the mem on X card get's to low it can bug.
The mem on the 260 I'm using right now is like this, I try and keep a load on the card best I can, but if you lock up to offen, and do a number or re-boots, then sit idle as you set up for the bench for too long. The mem gets covered in ice.
With LN2 it's better, as you can hold the pot at say -20 as you do these things, and take it lower just before you start the bench.
But with Dice (what I use the most at this time) it's at -68 or soo the whole time.
Quote:
Originally Posted by Chuchnit
Thanks Deanzo. I directed that at dinos cause he's a posting ninja  I pretty much knew what blocks fit what. So what kind of swing do you see with say a 285/4890 with full vmods? |
That will change from user to user, I don't find it to bad. But you need to keep a better eye on it and really control your pours.
Where as the Tek 3 will hold the load soo much longer, and if you over pour it's not the end of the world.