View Single Post
  #9  
Old 08-12-2010
Witchdoctor's Avatar
Witchdoctor Witchdoctor is offline
OCA Gladiator
 
Join Date: Nov 2009
Posts: 6,039
Rep Power: 22
Witchdoctor will become famous soon enough
Default

If carful no need to recharge refrigerant system

the evap will be submerged .... to chill the water

use some type of glycol to keep mixture from freezing but watch you vicosity to save your pump from pushing sludge though the lines

open or closed loop will work depending on preference

Closd would be cleaner but not as effective

just grab a rubber made cooler for a res ... large enough to submerge evap and closed loop if desired ....

So to get started

1. closed or pump and dump

2. just CPU or GPU loop as well

3. Draw up realistic demensioned drawling of system

4. know size of res and purchase

5. Remove casing from AC unit with out damaging anything

6. Plan and create a fan system/casing/bank for heat removal on the condensor

7. Compresor and eletronics stand to be incoperated with condemnsor or not

8. submerge evap

8. execut water cuircuit in and out of res regaurdless of type

9. Seal said res

9. install blocks/pump/pumps/and fill with gloycol distilled water solution

10. wire up pumps and test

11. fire compresor and let run for an hour

12. test viscosity of loop and adjust as needed

13. Tear da bot up ......

this is not meant to be a step by step all inclusive guide... just a generalization of the events that must occure to make this happen ....

Do you have any mechanical ability what so ever as it will be helpful ...

Best of luck ....
__________________
You don't need a reason to help people
Reply With Quote