Heres the deal. I'm using ROG to bump up after i get into windows.
Quote:
Originally Posted by HITandRUN
BIOS settings by Duke Via Splave
Code:
Target CPU Frequency 5845MHz
Target DRAM Frequency 1339MHz
LN2 Mode: Enabled***
QPI Loadline Calibration: Enabled***
Sync Mode [Disabled]
AI Overclock Tuner [Manual]
OC From CPU level Up [Auto]
CPU Ratio Setting [35.0]
CPU Turbo Power Limit [Disabled]
>CPU Configuration----------------------------
CPU Ratio Setting [35.0]
C1E Support [Disabled]
Hardware Prefetcher [Enabled]
Adjacent Cache Line Prefetcher [Enabled]
Intel(R) Virtualiyation Tech [Disabled]
CPU TM Function [Disabled]
Execute Disable Bit [Disabled]
Intel(R) HT Technology [Disabled]
Active Processor Cores [All]
A20M [Disabled]
Intel(R) SpeedStep(TM) Tech [Disabled]
Intel(R) C-STATE Tech [Disabled]
C State package limit setting [Auto]
----------------------------------------------
BCLK Frequency [167]
PCIE Frequency [103]
DRAM Frequency [1339]
UCLK Frequency [3683]
QPI Link Data Rate [6027]
Memory Configuration Protect [Enabled]
>DRAM Timing Control--------------------------
CAS# Latency 9 [6]
RAS# to CAS# Delay 9 [7]
RAS# PRE Time 9 [6]
RAS# ACT Time 24 [18]
RAS# to RAS# Delay 5 [4]
REF Cycle Time 88 [72]
WRITE Recovery Time 10 [10]
READ to PRE Time 7 [6]
FOUR ACT WIN Time 20 [Auto]
Back-To-BackCAS# Delay 0 [Auto]
Timing Mode 2N [1N]
Round Trip Latency on CHA Auto [60]
Round Trip Latency on CHB Auto [62]
Round Trip Latency on CHC Auto [64]
WRITE To READ Delay(DD) 8 [Auto]
WRITE To READ Delay(DR) 8 [Auto]
WRITE To READ Delay(SR) 18 [Auto]
READ To WRITE Delay(DD) 7 [Auto]
READ To WRITE Delay(DR) 7 [Auto]
READ To WRITE Delay(SR) 7 [Auto]
READ To READ Delay(DD) 7 [Auto]
READ To READ Delay(DR) 6 [Auto]
READ To READ Delay(SR) 4 [Auto]
WRITE To WRITE Delay(DD) 8 [Auto]
WRITE To WRITE Delay(DR) 8 [Auto]
WRITE To WRITE Delay(SR) 18 [Auto]
----------------------------------------------
CPU Differential Amplitude [1000]
CPU Clock Skew [Auto]
IOH Clock Skew [Auto]
------------ Extreme Engine Digi+ ------------
Digi+ PWR Mode [X-Power]
PWR Volt. Control [10V]
Load-Line Calibration [Full]
CPU Voltege OCP [Enabled]
CPU PWM Frequency [1000kHz]
Extreme OV [Enabled]
Extreme OC [Auto]
CPU Voltage 1.72 [1.41250]
CPU PLL Voltage 1.90 [Auto]
QPI/DRAM Core Voltage 1.55 [1.31250]
DRAM Bus Voltage 1.68 [Auto]
>DRAM REF Voltages----------------------------
DRAM DATA REF Voltage on CHA [Auto]
DRAM CTRL REF Voltage on CHA [Auto]
DRAM DATA REF Voltage on CHB [Auto]
DRAM CTRL REF Voltage on CHB [Auto]
DRAM DATA REF Voltage on CHC [Auto]
DRAM CTRL REF Voltage on CHC [Auto]
----------------------------------------------
IOH Voltage 1.20 [Auto]
IOH PCIE Voltage 1.6165 [Auto]
ICH Voltage 1.205 [Auto]
ICH PCIE Voltage 1.60325
---------- Spread Spectrum Control -----------
CPU Spread Spectrum [Disabled]
DRAM Spread Spectrum [Disabled]
***on-board jumper dependant
* courtesy of donmarkoni @ i4memory.com |
[/QUOTE]