CC-Pot Rev1.0
 

Kool man, how much does it weigh?

i tried round and square pots....
round is a hit and miss with mounting...
square pots are easier to mount...


with ln2...

starting @ -100c with a heatload(wprime1024) of i7-980x(only an example)(say 1.6vcore again only an example) how fast does the temperature drop to -70c? this is without addition of liquid nitrogen... this is a question for how much the base can hold temps. i suggest a timer....

this is not to judge your idea.....i'm just curious.

thanks for posting ...what is the diameter? 80? 70?

Different people have different pouring styles. Patch likes a pot that warms/cools quick with a thin base. He likes to rapid pour.



Nice looking pot Crio. :thumbsup:

:black::black::black::black:

Nice looking design .... how deep are each of the steps at the bottom ? hard to tell from pics .... Thta would be adjustable for future pots to tune them in for your prefered temp holding preference.

wet sanded down and buffed on the outside and it would be a very sexxy peice of hardware ....

What type of mounting backet you using ?

No shit, I know who the question was for. That's strike two Honda. I'm reluctant to let you make it to three. You just come into every thread acting like you are a know it all engineer and have confrontational post. You post could easily be taken as putting his design down. I suggest you think very hard about your next response.

The diameter is 7cm and its 12cm long
The design was a mix of three things.Old MickeyMouse design (the steps),Gorillopot and my ideas.I will soon test it with a hexa core CPU and let you know.The holddowns will be ready tommorow.They will be made from acetal.

Are you selling these in the future or is this just a personal project?

If CC-Pot performs as i want it to i will sell for sure.