Who wants to mod?
 

These 9600 GSO's are just screaming to be modded...anyone want the task? . :thumbsup:

Think this was the best I got out of them so far... http://hwbot.org/community/submissio...3_287774_marks

http://i434.photobucket.com/albums/q...9/DSC00409.jpg

lemme see if i can find any info on taht PCB for ya ;)

can you get a better pic of front and rear? better quality?

are there any IC's under the SN sticker?

I am video card stupid and I can't see for shit lol. They are 768MB versions P/N 768-P3-N968-TR if that helps any. :blink:

lol if you wanna ship me one ill take a look at it...


are theer any black squares underneath the serial number sticker?

I see nothing under there like you describe. I would'nt want to ship unless I have a definitive answer. ;)

http://i434.photobucket.com/albums/q...9/DSC00410.jpg

I understand,

Lemme see If I can get a close up look at one of these first ;) im sure it wont be too bad, but lemme see what teh power circuit looks like

Look like that?

http://forums.techpowerup.com/showthread.php?t=66213

Obviously fromthe guides the back side of the board is only need for measuring points

and no not willing to mod it for yah. Splave might if you are closer to him.. dont want to overwhelm him with requests though.. The man benches like no tomorrow! dont want to interrupt him for a 30-60 minute mod ;)

LOL jk

Once I get a few under my belt that looks like an easy one

Much easier then what I have lined up anyway :ohcrap:

I just put the water blocks on - going to see what improvement if any that brings. The last time they were benched was stock on air.

it doesnt look like taht from what i can tell.

I will get some good shots of one tomorrow to study at work