OK,
No software tweaks, just felling out the bios. Yesterday I tried one of the preset overclocking settings in the bios(no boot). So this AM I went off my memory, not sure why the auto settings really power the voltage on the CPU I think it was around 1.53v witch is way out of whack! Still relearning here......trying to get my hunger back :thumbsup:

Nothing spectacular, just wanting to see if this setup is gimped or not as I'm not gonna build around it if it is. Bare in mind this is a fixed board and new memory(same as old stuff). So far so good, I will decrease room temps then good harder eventually...

http://www.3dmark.com/3dm11/6903813

Rock it Philly ..................... :thumbsup:

Check!

A lil betta 5.0 I remembered I have to go higher in the OS :thumbsup: Again no world record just seeing. one GPU score

@WD them TITANS CRASH IT !!!

http://www.3dmark.com/3dmv/4759164

Baby steps
 

Just the CPU for now, I either borked something or I have a cold boot issue at minus 65 degrees, using a heat gun to try and wake her up now..............Kept crashing at 5300Mhz. Code was 101 that's power low right? Edit booting at 5300 now, minus 42

what you using dice or LN2

the sandies don't need extreme cold, just get max multi and that is typically the lid, as far as i understand it with Sandies

Dice block cant vailidate im @5700

it keeps defaulting to 3200?

Well after break down, I found a bent CPU PIN :ohcrap: it went back with no issue

So today the UPS guy came by, 2 780 TI'S Beat IT!

http://www.youtube.com/watch?v=tiVxzKDWJqE

http://www.3dmark.com/3dm11/8113276

25929 in 3D mark 11:laughing: @4920Mhz

That memory is beastin bro, just need some core to go with it

Nice ......... :thumbsup: