I have yet to get a reply, it just blows!!! I'm thinking of just putting a fan over it.........

Did you try and pull the fan off the board for a sec and see if maybe it wasn't just hanging up/ Maybe its rubbing on something internally?

I didn't remove it as its got a bunch of screws through the board, but it spins freely I tried a few times to jump it to see if it would work but nothing. At this rate, its gonna be two months without that computer.
I think the writing is on the wall here :thumbdown:, I have always had good service from them in the past!

I may be but that fan only runs when temps are calling it to run like the AsRock E11 ? But if you jumped it out with another power source I geuess that woulkd not come into play anyway :ohcrap:

what is the fan size

could you retro a 40MM of this VGA cooler

http://www.frozencpu.com/products/18...0c16s501#blank

IDK, but yea there might be a profile for it in the bios. That's a thought.

There it is, PCH control :thumbsup:

http://www.overclockaholics.com/foru...1&d=1374279089

Here is there response, the fan worked fine when it left here " Thank you for your response. According to the repair history, the repair facility did not do anything to the north bridge. I would suggest trying to blow the dust out and check with the power connection with the fan on the unit. Please do let me know if the problem still persists."

ugh!

Thanks guys! I'll look in the bios, mine always was on before.

So I went and started to remove the fan assembly, NOT so easy as it is heat piped to every heat sink on it . So I only hand tightened the screws when I put them back. then went into the bios and adjusted the PCH as you out lined. BOOM working!!!!! :clapping:

Funny when we know more than the techs at the manufacturer.

YUP YUP! :good:
I'm just grinning, now I can install everything!!!:clapping: