[Cecil]

Originally Posted by DOM

i never done ups over night cost to much lol

so when is it going to be benched on ?

do you do more water cooling the ln2 ?

It wasnt overnight, he got regular ground and it got here in a day.

Hope to have my loop up before the weekend. I dont do LN2. I have a pot for DICE, but havent gotten to it yet. Not sure if I will cause I have an AC apart I can use to chill the water.

[Neuromancer]

I do UPS ground with newegg all the time, 90% of the time its overnight

(Because newegg's warehouse is close)

[DOM]

Originally Posted by Neuromancer

I do UPS ground with newegg all the time, 90% of the time its overnight

(Because newegg's warehouse is close)

you suck lol i always have to wait 3days :(

but now they charge sh on almost everything now

[Witchdoctor]

Hey C looks good

How did the panels ship .. any dammage ?

Please make sure the rad holes line up before you throw any more coats on

Just in case they need adjusted .... Kinda done on a wing and a prayer not having the actual unit there. I usally make card board templates of that many fixed holes due to having to free hand everything as I do not have a drill press and proper machienery

the two holes that were added from the OP are for the push pull fan wires

and the notch in the front is to accomidaste the tubes according the the diagram

Best of luck hope you like it ......

[DOM]

Originally Posted by Cecil

It wasnt overnight, he got regular ground and it got here in a day.

Hope to have my loop up before the weekend. I dont do LN2. I have a pot for DICE, but havent gotten to it yet. Not sure if I will cause I have an AC apart I can use to chill the water.

aww i c

i was thing of moving my rack to the garage and using the ice box for the gpu loop but i dont think i have long enough tubes to run it but its a mess in there wife doesnt know what the dumpster is for

[Cecil]

Originally Posted by Witchdoctor

Hey C looks good

How did the panels ship .. any dammage ?

Please make sure the rad holes line up before you throw any more coats on

Just in case they need adjusted .... Kinda done on a wing and a prayer not having the actual unit there. I usally make card board templates of that many fixed holes due to having to free hand everything as I do not have a drill press and proper machienery

the two holes that were added from the OP are for the push pull fan wires

and the notch in the front is to accomidaste the tubes according the the diagram

Best of luck hope you like it ......

Everything seemed fine. Holes looked like they match up, havent tried with screws though.

I screwed up with the OCA stencil, the paper moved and smeered the white everywhere. Had to go through more black to cover it up, so Im only going to primer the bottom piece.

[Chicken Patty]

Subscribed man, looking good so far

[Cecil]

Witch, I have 3 extra nuts, but missing a washer. Is there suppost to be extra nuts (I can pick up the washer at the hardware store)?

[Cecil]

Got it finished, and put together.

[Chicken Patty]

That looks freakin' great!!!!!!