[Neuromancer]

Well I bought a DMM yesterday.

Came home and tried a pencil mod on my good 4850.

Destroyed it :( (corrupt 2D screen 3d does not work at all)

Put the old one back in and decided, ok.. I can not compete in 3d anywway... so will just run some 2D benches. I was on HWbot, someone on water managed to beat my air cooled cpuz run by 10MHz

Installed the new Blade sticks of ram did not spend the time to get to know the ram and went for it :p

Now I have an entire rig that will not boot up. :(

On a positive note if the blades are any good I will be getting my 920 back online and trying for 4GHz on air with that But it will not be for a couple of days. (The asus board sucks for BUS clocking, my Foxconn however does much better : ))

Since I will not be home for a few days (going to dog sit at my aunts house). This is getting put off.

I am goign to try and build a portrable bench table while I am there, and I will bring a heatsink and maybe try clocking that 3400 Venice that is there


Needless to say, yesterday was a bad day for me with Hardware :( Hoping the future is a little more kind

(I will still be around the forums lurking and reading though )