[ReverendMaynard]

Originally Posted by Chuchnit

If by thaw, you mean FIRE, then you are correct. NEVER put a flame to acetone. I will never end the way you want

this dude says it's okay...then again he has no lips so wtf does he know?

[Splave]

^ pissed my pants

[MaadDaawg]

Still climbing the learning curve :( jeez

Earlier I was running with 27 multi and 2:10 divider and got the excellent no CB numbers I put up before. This time I ran it with a 35 multi and a 2:14 divider and it cold bugged out at me around -99C and wouldn't reboot until I was above -70C. Was on the verge of beating my wp score when it froze on me

Potentially dumb questions follow, so consider yourselves warned

Is the most likely cause of the change of behavior due to the change in the parameters I had the cpu running under, and/or, could it be attributable to a potential mounting problem? Both mounts looked good, but the second time around I think I used a little more TIM which made a slightly thicker layer. Could prolly be one and/or the other?

Last question and a statement: Does everyone use AS Ceramic with LN2? I HATE AS Ceramic but have been using it anyway... it's like effing putty

[Buckeye]

Same TIM I use on everything.

Often times soft cold boot problems come from teh MB and not the CPU. Just insulate well.

I have seen people use so much TIM its like spreading tooth paste all over the place. I just use a little, spread it around and all is good.

After I mount the pot I fire up the comp and bring it into the BIOS, no cold in the pot yet. I let it warm up to 50-60c or so then shut off the comp. The heat will help settle down the TIM before going cold.

[MaadDaawg]

I've been starting the rig w/ no juice in the pot and letting it boot but haven't taken it to 60 yet.. I'll give that a try. Going to go back to my old TIMing methods and see if that makes a difference.

Thinking back.. way back to this morning I think the TIM job was better than the PM one. Still thinkin the multi and divider had something to do with it though ???

[Kal-EL]

Just remember that with more cold, generally you'll need less voltage to run at much higher clocks. You're approach to voltages will change.

Where previously, you needed more vcore to run at higher clocks, you have now maxed the other voltage ranges and need to bump things like vdimm up in order to remain stable at your new found clocks.

[Neuromancer]

Originally Posted by ReverendMaynard

this dude says it's okay...then again he has no lips so wtf does he know?

LMAO I was just watching that on youtube the other day... how bizzare is that.

I prefer the "ride the snake" infomercial (SNL?) to Firemarshall Bill though.

[MaadDaawg]

Yeah Kal - the equasion has changed and I think one of the issues I had today was giving it too much vcore. Prolly gonna take me a few dewars worth of LN2 to dial in the right relationships... but sure is fun

[Splave]

awesome man, super glad it working for ya

[ReverendMaynard]

Originally Posted by MaadDaawg

Yeah Kal - the equasion has changed and I think one of the issues I had today was giving it too much vcore. Prolly gonna take me a few dewars worth of LN2 to dial in the right relationships... but sure is fun

In bold = what it's all about. Keep at it Maad it'll happen.