[Splave]

Originally Posted by DOM

Idk what Silicone to get there's a shit load

Im thinking the sf3d method is pretty interesting, he places the ihs less chip in the socket then places the ihs back on properly and holds in place while clamping down the hold down bracket. That way you can change the TIM over and over again but still get the pressure of the bracket. I can just see myself fucking up the silicone and not being able to get it back off to fix it lmao

[DOM]

yeah ill give that a try idk if i should test before and after temps that to much work lol

[Splave]

done

[punx223]

remove IHS is really easy on IVB just remember not to dig Razor into Green PCB area of Chip.... keep it level or even point up a lil if possible.... the black is just like a rubber/silicone = easy to cut through once started the razor should just kinda glide through it nice and smooth.

[punx223]

also standard clear silicone will work fine but remember this stuff is not cement so can be cut off just like the black stuff

just dont use too much as some silicone can expand slightly and dont wanna make IHS contact worse than before...

If going for bench I would say leave IHS loose and hold on while loading so can be remove as needed.

[DOM]

Originally Posted by Splave

done

nice i was sleeping well im still half alseep ill do mine in a few hrs

[Splave]

running stupid cool 32m 5ghz 1.425v hottest it got 53c

[DOM]

Did it also lower the volts ?

[Splave]

^ just benched on ln2 and its worse lol I wouldnt do it dude. 20mhz less cpu-z and not even 6.4ghz 1m stable at same volts lol oops

It could be because I ran out of gelid and had to use this no name paste between the pot and ihs....I hope thats all it is.

[DOM]

No name paste really

I never used gelid before so hope for better results I got 5 tubes