[marcam923]

Here is a little sneak of the big reveal later.

May end up being tomorrow depending on when I can get everything else done for the final pictures.



Let me know what you think!!!

[Chicken Patty]

damn bro thats good for air man, awesome! Is your CPU lapped to?


Liking how the card is looking now

[marcam923]

Originally Posted by Chicken Patty

damn bro thats good for air man, awesome! Is your CPU lapped to?


Liking how the card is looking now

Thanks!!

No the cpu is not lapped, just a really nice batch.

Gonna do a few runs in a minute here see what I can really get out of her!

[Chicken Patty]

Originally Posted by marcam923

Thanks!!

No the cpu is not lapped, just a really nice batch.

Gonna do a few runs in a minute here see what I can really get out of her!

im in shock with your temps bro! Keep us posted on the runs

[marcam923]

Originally Posted by Chicken Patty

im in shock with your temps bro! Keep us posted on the runs

http://service.futuremark.com/compare?3dm06=12008019

[marcam923]

Originally Posted by marcam923

http://service.futuremark.com/compare?3dm06=12008019

5.343 wprime 32

8.844 super pi 1M

[Chicken Patty]

damn dude, thats a nice CPU you got there. Great Wprime run bro

[marcam923]

Originally Posted by Chicken Patty

damn dude, thats a nice CPU you got there. Great Wprime run bro

Thanks! Yeah fortunately I have a microcenter nearby and was able to get me a nice batch in store

My ram is really holding me back from pushing it any harder, that is just the beginning!

My ram will not run higher than 1320MHZ which limits me right now, but hopefully in the near future that will change!

[marcam923]

Onward and upward.

Picture of the preparation of the side panel for the custom print!



tools needed, squeege, felt squeege for after decal is installed so as to not scratch it after the pre-mask is removed, knife, new blades, and spray bottle.





the print before application:



and the side panel after installation:



then the panel installed on the computer!





Here in the front panel, we see the fan controller and underneath the three switches that control the cold cathodes, and the strobes!



then some inside shots, both graphics cards installed, and the other part of the print matching mounted to the inside of the back panel, to bring the "COSMIC" effect into the case, going along with the matching black hardware, and metallic black paint on the inside of the case!











Notice how the small prints mounted on the graphics cards match the main print too!



Next posts will be tomorrow, some full exterior and interior shots, another little mod to the inside, to highlight the print on the graphics cards, and hopefully some movies highlighting the overall lighting effects!

Enjoy for now!

[Chicken Patty]

dude, that's a kick ass side panel. Got mixed feelings about it on the video card, but the side panel rocks!