Nothing is here yet, but since I can't wait anymore, I disassembled some of my old stuff and here is what I came up with.
This is a testing cable, as some of you guys know I really like play with SMD light strips
but by having to solder a 12v + ground wire on the strip EVERY time when i need to test it is getting really freaking annoying, so I ordered two pairs of alligator clips to be soldered on there.
(alligator clips aren't here yet but the sleeving part is pretty much done)
First time sleeving cables, let me know how it looks.
I know the white heatshink is not measured right, but other than that...
give me some feed backs.
Before:
This was one of those Molex to SATA Y-split cables, after cutting off the SATA header it left me Yellow (12v) + Black (G) + Black (G) + Red (5v)
After:
Found some heatshink tubs in my dad's workshop
Red heatshink tubes are 6mm in diameter
White I think its 4~5mm not really sure.
Close up look:
Line-in Up
Line-in Down
Line-out
NOW, I REALLY HAVE TO STUDY FOR FINALS NOW