MaadDaawg
05-20-2010, 01:47 PM
Finally got my fatboy insulated and mounted to the card :) It's sitting in the slot but I can't run it yet cause I can't find my vaseline :ohcrap:
Ended up wrapping the entire pot with blue tape, then armalex (cut outs for the fittings etc), then a sheet of frost king all the way around too :eek: That did a pretty good job of eating up most of the gap but I erasered the fitting around the copper block then stuffed eraser into the sides and bottom and top after mounting the pot to the card.
Used 13 copper moffset blocks, 6 black aluminum chip sinks, and 7 low profile memory chip sinks.
Looks pretty bad ass :D As soon as I can find a black Sharpie so I can write MD on it I'll take a pic :thumbsup:
added: I broke my favorite insulating tool right at the end :ohcrap: my wooden chopstick snapped right in half dammit :D
Ended up wrapping the entire pot with blue tape, then armalex (cut outs for the fittings etc), then a sheet of frost king all the way around too :eek: That did a pretty good job of eating up most of the gap but I erasered the fitting around the copper block then stuffed eraser into the sides and bottom and top after mounting the pot to the card.
Used 13 copper moffset blocks, 6 black aluminum chip sinks, and 7 low profile memory chip sinks.
Looks pretty bad ass :D As soon as I can find a black Sharpie so I can write MD on it I'll take a pic :thumbsup:
added: I broke my favorite insulating tool right at the end :ohcrap: my wooden chopstick snapped right in half dammit :D